This is an instructional sheet sent out with each of our Waltco super switches. This explains the replacement process and is provided by the manufacturer, Waltco lift gate.
New Push Button Control Switch
Replacement Switches do not use a ground wire.
Green - Power
White - Power
Black - Lower
See next page for comparison with earlier switches.
Wires must not overlap each other before mounting. Do NOT cross wires.
Wires must also clear the plastic extrusions on the switch before mounting
Color Codes – Connect wires per chart below.
Function Before 4/2004 04/2004 to 03/2008 After 03/2008
Heat shrink all connections. If switch cord and pump unit have plug in connectors, new switch should plug directly into existing gendered connectors on pump, regardless of wire colors.
WDL inside controls
These instructions assume that the existing four-wire inside harness will be reused.
Remove old Switch, and cut wires just below old splices.
Splice wires, and heat shrink connectors.
Important: Switch wires should always be protected from sharp edges.